Burris Eliminator III User Manual download pdf (Page 2)

1. Battery Installation or Replacement

Unload the gun. Unscrew the battery cap on the left side of the

scope. Install a lithium CR123 battery. Reinstall the battery cover.

NOTE: A sticker on the underside of the battery cover contains

basic set-up instructions.

2. LaserScope Battery Life:

Battery life is nominally rated at 5000 cycles. This will vary

depending on the quality of the battery and the temperatures at

which the unit is operated. Batteries lose a good deal of their

power potential in colder temperatures.

3. Start the electronics

Press one of the main switch buttons (On/Range buttons) on the

lower front of the scope. There is one on either side, just behind

the Objective Bell. Either button will work. Look through the

scope. It should show two things: the Yards (Y) or Meters (M)

indication illuminated along with the battery status indicator. The

indicators will stay on for 8 seconds.

4. Electronic Basics

Having started the electronics, aim at a target. Press either

On/Range button again and you will get one of the following 3

displays sets:

1. The scope will display the range to your target, and a 10

MPH windage offset at the top. The scope will also illuminate

a hold over dot on the lower crosshair post. The dot display will

be corrected for the actual magnification setting. After 10

seconds the unit, range, and battery status will go off, but the

Hold Over Dot and Windage will continue to be displayed for an

additional 80 seconds, or until you press an On/Range button

again.

2. A range is successfully taken, but the distance is beyond

the limits of the selected Cartridge. The scope displays the

“Too Far” code along with the correct range. The “Too Far”

code is; the Center (“Zero”) Dot on steady, and bottom most 4

Dots will be flashing. Everything except the Dots will go out

after ten seconds. The Dots will remain for the entire 90 sec.

On/Range Switch

(One on each side)

IMINATOR

III

™

SER

OPE

Setup and Brightness

ontrol Switches

Distance

Windage

Offset

Hold Over Dot

X96 Reticle

Battery Cover

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Burris Eliminator III User Manual Page 2

Comments to this Manuals

Related products and manuals for Optics Burris Eliminator III